ECO-160 A
Recessed solar studAluminium solar panel with GPS
Designed for high-traffic environments, the ECO-160 A road marker features a reinforced structure with two brackets that protect the solar module. Its low profile and simplified maintenance ensure long-lasting performance. Available as an option with the latest GPS technology, it automatically synchronizes its flashing pattern with all other markers at the same site.
Applications
- Cycle track
- Eco-district
- Parking
- Road & Expressway
- Pedestrian crossing
- Roundabout
Features
- Colors temperature
- Materials
Aluminium (cover + tank), Polycarbonate (optic module), Silicon (photovoltaic module)
- Protection ratings (IP)
IP 68 – 5 metres
- Impact energy
IK10 + 100 J - suitable for 40-tonne trucks
- Weight
1.1 kg
- Dimensions
Top diameter: 160 mm
Overall height: 57 mm
Mounting depth: 47 mm.
Off-pavement bracket projection: 0 mm at ends / 10 mm at center
- Energy storage
Capacitor / Ni-Mh battery
- Operating temperatures
-30°C to +85°C
- Customization
Aluminium cover, anodized, powder-coated (RAL to choice), shiny, matt
- LED
1 LED, 2 LED, 3 LED, 4 LED, 5 LED, 6 LED, Fixed, Synchronized flasher
- Characteristics
Unidirectional or bidirectional wayfinding, 1 to 3 LEDs per side. Fixed or flashing mode (2.5 flashes / second). GPS option for inter-pin flashing synchronization without wiring (1 flash per second ±10%) for NiMH batteries only.
Installation
Choice of adhesive – For installation on sites where vehicles are likely to drive over the pads, we recommend the use of SIKADUR 42+ HE adhesive. Installation must be carried out at suitable temperatures, respecting the curing time before traffic (see adhesive instructions). Any other choice of adhesive is the responsibility of the installer.
1 – After locating the studs, drill a circular hole with a diameter of at least 170 mm and a depth of at least 70 mm. The installation fins can only be used for core holes up to 174 mm in diameter.
2 – Carefully brush and clean the hole to remove all dust and traces of moisture which would reduce the effectiveness of the adhesive.
3 – Fill the hole with sufficient sealant: after installing the installation aid on the stud, insert the stud into the core hole. The glue should rise to ground level when the fins come to rest on the edge of the hole. Make sure the LEDs are correctly aligned at this stage.
4 – Keep the weight on the stud and allow the seal to set long enough before applying any mechanical stress. Remember to smooth the joint for a neat installation. Once the sealant is dry and strong, break off the installation fins to remove the emerging part.
Note – Throughout these operations, keep the solar module and LEDs clean and protected.
Failure to comply with these instructions may result in suspension of the warranty.
Warranty
ENERGY STORAGE
a. Capacitor: average lifespan in excess of 10 years. 2-year warranty*
b. Ni-Mh battery: average lifespan over 7 years. 2-year warranty*.
Easy maintenance via 6 screws in the aluminum cover, without having to unseal the recessed bowl.
* The warranty applies in the event of permanent shutdown of the autonomous lighting system under normal use and installation in accordance with our recommendations. It consists of replacing the faulty component with an identical or equivalent item, subject to return to ECO-INNOV for analysis. On-site intervention costs are not included. Mechanical damage is not covered.
We recommend installing our solar equipment on sites with good light exposure for optimum performance.
Recycling
Certifications
Bernin (France)
Synchronized flashing wayfinding of a pedestrian crossing