ECO-143

Features Installation Warranty Applications examples

Recessed solar panel

Flush-mounted solar panels for architecture and urban planning

With its design inspired by pavement cladding, ECO-143 blends seamlessly into urban planning and architectural landscaping. Flush-mounted and free-standing, it diffuses an effective low-angled light while maintaining a low bracket projection for pedestrians and two-wheelers. Direct access through the hood ensures rapid maintenance and long-lasting operation.

Applications

Pontoon & Footbridge
Cycle track
Park & Square
Eco-district
Footpath

Ask for a quote Data sheet

Features

Colors temperature

Materials: Aluminum, Polycarbonate, Silicon (photovoltaic panel)

Protection ratings (IP): IP 68 – 5 metres

Impact energy: IK10 + 100 J - suitable for pedestrian crossing, cycles and light vehicles

Weight: 1 kg

Dimensions

Top diameter: 145 mm

Total height: 87 mm

Off-pavement bracket projection: 3 mm at ends / 15 mm at center

Power supply & consumption: Capacitor / Ni-Mh battery

Operating temperatures: -30° C to + 85° C

Customization: Aluminium cover, anodized cover, powder-coated cover (RAL to choose from), shiny cover, mat cover

LED: 1 LED, 2 LED, 4 LED

Characteristics

Unidirectional or bidirectional wayfinding, 1 to 2 LEDs per side

Fixed or flashing mode 2.5Hz (2.5 flashes per second) ±10%.

Installation

1 – After locating the studs, drill a circular core with a minimum diameter of 130 mm and a depth of 100 mm.

2 – Carefully brush and clean the hole to remove all dust and traces of moisture which would reduce the effectiveness of the adhesive.

3 – Pour SIKADUR 42+ HE sealing adhesive into the hole, then insert the stud into the adhesive. It’s imperative to use a sufficient quantity of glue: there must be sealing glue under the entire lower part of the cover (a thin layer of glue protruding from the cover). The edge of the hood must be flush with the level ground. Pay attention to LED orientation.

4 – Maintain a weight on the stud and respect the time required for the sealant to set (refer to the manufacturer’s instructions in the adhesive’s technical manual).

Note: keep the solar module and LEDs clean and protected throughout these operations.

Failure to comply with these instructions may result in suspension of the warranty.

Warranty

BATTERY
a. Capacitor: average lifespan in excess of 10 years. 2-year warranty*
b. Ni-Mh battery: average lifespan in excess of 5 years. 2-year warranty

Maintenance via removable cover.

* The warranty applies in the event of permanent shutdown of the stand-alone lighting system under normal use and installation in accordance with our recommendations. This consists of replacing the faulty item with an identical or equivalent one, subject to the item being returned to ECO-INNOV for analysis. On-site intervention costs are not included. Mechanical damage is not covered.

We recommend installing our solar equipment on sites with good light exposure for optimum performance.

Recycling