ECO-57

1 – After locating the studs, drill a circular hole at least 62 mm in diameter and 50 mm deep.

> We recommend a 5 mm perimeter seal around the bezel.

2 – Carefully brush and clean the hole to remove all dust and traces of moisture which would reduce the effectiveness of the adhesive.

3 – Pour a small quantity of sealing adhesive into the hole to seal the base of the stud. The glue must not rise above the lower level of the collar, which must be free to be unscrewed for maintenance.

> We recommend a two-component epoxy adhesive such as Sikadur 30 for installation on asphalt, concrete or stone.

4 – After allowing the first seal to dry for a few minutes, finish with a flexible joint around the collar or with a thin mortar that will be easy to remove for maintenance purposes.

> We recommend an anti-UV mastic adhesive such as Sikaflex 521 UV, unless otherwise indicated by the nature of the substrate.

5 – Clean off adhesive residues and allow to dry for several hours, depending on ambient temperature (refer to the instructions for use of the adhesives used).

Note: keep the solar module clean and protected throughout these operations.

Failure to comply with these instructions may result in suspension of the warranty.

Average lifespan 10 years
Warranty 2 years*.

LED module maintenance by unscrewing the collar.

* The warranty applies in the event of permanent shutdown of the stand-alone lighting system under normal use and installation in accordance with our recommendations. This consists of replacing the faulty item with an identical or equivalent one, subject to the item being returned to ECO-INNOV for analysis. On-site intervention costs are not included. Mechanical damage is not covered.

We recommend installing our solar equipment on sites with good light exposure for optimum performance.

Recycling

Certifications